How can we solve the blockage found in the process of using the Slurry Pump? Many customers think this is a very complicated problem, but if this kind of blockage problem is not handled properly, it will easily cause damage to the equipment, thereby affecting the efficiency of use. Therefore, everyone should pay special attention to it. The problem can be easily solved by grasping the following points.
(1) The solid deposits in the volute of the Horizontal Slurry Pump make it clogged, and measures can be taken to remove the clogging.
Slurry Pump
(2) If the shaft is different from the refill box, the main reason is the large machining error and incorrect installation. Attention should be paid to check whether the installation is correct after installation. If the sealing water ring is severely worn, it needs to be replaced with a new one. If the clean water pipe is blocked, the sealing water cannot enter the middle of the packing, causing the packing to wear quickly and cause material leakage. The blocked water pipe should be dredged to keep the sealing water clean.
(3) If the impeller or water inlet and outlet pipes are blocked, clean the impeller or pipes. If the impeller is severely worn, it should be replaced. If there is air leakage from the packing port, the packing should be pressed tightly. If the conveying height is too high, the loss resistance in the pipe is too large, reduce the conveying height or reduce the resistance.
The Slurry Pump Manufacturers has popularized so much knowledge for everyone, please consult us for more details!
