Slurry Pump Suppliers share with you about how to improve the efficiency of slurry pumps, I hope it will be helpful to you.
Slurry pump usually consists of pump head, support, shaft seal. If the slurry pump is not used properly, it will lead to pump energy waste, wear and tear too fast and other problems. For this problem, as long as we choose and use the slurry pump correctly and reasonably according to our own situation, we can fully realize the value of the slurry pump
Slurry Pump
The Slurry Pump should be selected according to the actual head requirements, reduce the number of installations and save energy. In addition, should pay attention to the calculation of head, should consider the head loss, to avoid pump head is not enough slurry pump lining material variety, such as high chromium cast iron, polyurethane, wear-resistant rubber, etc.. Slurry pump has good wear resistance, high chrome white cast iron material although has good wear resistance, but the toughness is poor, can not quickly withstand the impact of large particles, otherwise it will lead to impeller surface material off, the section is easy to form pits due to corrosion; wear-resistant rubber material wear resistance and corrosion resistance is better than metal materials, and has elasticity, but only for conveying slurry without angles. Therefore, slurry pump lining selection should be reasonably selected according to the type of ore, in order to improve the utilization rate of the pump.
It is recommended that the power of the motor and slurry pump should be reasonably matched, and the latter's matching power selection is small, which will lead to insufficient feeding of the slurry pump, when installing the slurry pump, to minimize the number of elbows, or cancel the "three valves". The use of water pipe diameter is slightly larger than the slurry pump diameter of a class, can improve the efficiency of pump delivery.
The company also provides Flue Gas Desulfurization Pump, if you need, please feel free to contact us!
